Avery Berkel L126 Calibration ★

Gently press the using a pen or small screwdriver.

Search for: or contact Avery Weigh-Tronix support (they own Avery Berkel). For some regions, a security calibration switch or password may be required — check if your scale has a physical switch under the platter or a dip switch on the PCB.

Place the scale in a room with a stable temperature (ideally around 20°C / 68°F). Avoid areas near heating vents, air conditioners, or direct sunlight. avery berkel l126 calibration

Calibration is not a one-time task. To maintain the integrity of your weighing processes, establish a regular calibration schedule based on the manufacturer's recommendations and your usage frequency.

: After saving, the weight is removed and reapplied to ensure the reading is repeatable and accurate. Technical Resources Gently press the using a pen or small screwdriver

To ensure the calibration was successful, perform a verification test:

Ensure the scale is positioned on a flat, stable area. Step-by-Step Avery Berkel L126 Calibration Procedure Follow these steps carefully to calibrate your L126 scale: Place the scale in a room with a

Follow these manual steps to access the internal service menu and calibrate the load cell. 1. Access the Service Menu Turn the scale completely off using the power switch.

Clean the housing with approved electrical contact cleaner. Ensure the internal board receives direct physical actuation. Regular Maintenance and Compliance

: Turn the scale on and allow it to warm up for at least 15–30 minutes. Step-by-Step Calibration Procedure