Satlink Ws-6933 Software Update |top| 〈Instant ✮〉

Do not turn off the meter during this process , or the device may be damaged (bricked).

| Model Variant | Key Identifier | Correct Firmware Source | | --- | --- | --- | | | Boot screen shows “Satlink 2.0” | Manufacturer’s site (rare) | | WS-6933 V3.0 (2021+) | Menu has “Blind Scan” and “Auto Roll” | Third-party forums | | WS-6933 Clone (Chinese) | Poor build quality, no official support | Community modded firmware |

If your meter is currently powering on, locking DVB-S/S2 signals (QPSK/8PSK), and displaying spectrum data correctly, do not attempt to update the firmware. satlink ws-6933 software update

Inside the PC software, select the "Browse" or "Load" option and navigate to your downloaded firmware file. Initiate Transfer:

This guide provides a complete overview of the software update process for the handheld satellite meter. It includes information on the device's features, step-by-step instructions for the update procedure, and troubleshooting advice. Do not turn off the meter during this

Ensure the battery is charged to at least 70% to prevent it from dying mid-update.

The device screen or the PC software will display a progress bar. Do Initiate Transfer: This guide provides a complete overview

or turn off the device until the progress bar reaches 100% and a "Success" message appears. Once finished, restart the meter. Go back to System Setup to verify the new version number. Fujian Satlink Electronics Co., Ltd. 3. Updating the TP (Transponder) List

If your PC doesn't detect the device, check your Windows Device Manager to ensure the proper USB-to-Serial drivers are installed. Update Failed:

Use the keypad to update the Frequency, Symbol Rate, and Polarisation. Save the changes before exiting.