Cobra 3195 Alarm Manual Full //free\\ Jun 2026

Monitors doors, boot/trunk, and bonnet/hood.

The ultrasonic sensor sensitivity may be set too high. Adjust the potentiometer screw on the side of the central module counter-clockwise to reduce sensitivity.

The system will confirm entrance into the learning procedure with a long blink of the indicators and the LED will light up in fixed mode.

If the LED flashes rapidly upon disarming, the system was triggered during your absence (see Section 6 for LED flash codes). Bypassing Ultrasonic Sensors (Pet/Drop-Window Mode) cobra 3195 alarm manual full

: You can find full PDF documentation for similar 3100-series models (like the 3198) on or the official Vodafone Automotive Manuals Portal Do you need the specific wiring diagram for installation or the programming code sequence for a new key fob?

On the final digit, leave the ignition key . The LED will flash rapidly to indicate the system is in programming mode.

Cobra 3195 Alarm System: The Complete Installation, Operation, and Troubleshooting Guide Monitors doors, boot/trunk, and bonnet/hood

: Generally synchronized with your vehicle’s central locking. If using a Cobra remote, press the large button to arm (confirmed by two beeps and flashes) and the same button to disarm (one beep and flash). Emergency Override

: Connected to the vehicle's indicators to provide visual confirmation.

Dedicated for the transmitter and receiver ultrasonic capsules. Mount these at the top of the A-pillars facing the rear window. 4. Installation Guidelines The system will confirm entrance into the learning

Press and hold Button B to trigger the siren manually in an emergency.

Check that all doors, the boot, and the bonnet are closed properly before arming.