Locate network.cfg and (or rename it to network.cfg.bak as a backup). Locate network-rules.cfg and delete it (if it exists).
The most effective way to reset the network is to delete specific configuration files located in the config folder of your Unraid USB flash drive.
If your server is hooked up to a display and keyboard, you can reset the settings without moving the USB drive. unraid reset network settings install
Look for the following lines and update them to force DHCP and disable static assignments: USE_DHCP="yes" IPADDR="" NETMASK="" GATEWAY="" Use code with caution.
: Find and delete (or move to a backup folder) the following files: network.cfg (contains IP and DNS settings) network-rules.cfg (stores MAC address to interface mapping) Reboot and Reconnect Locate network
Are you using (NICs) or a custom 10Gb card ? Did this happen right after updating your Unraid version ? Share public link
If you cannot access the Unraid WebGUI or connect via SSH, you must physically access the Unraid USB boot flash drive to clear the network configuration. Step 1: Power Down Safely If your server is hooked up to a
and plug it into a different PC or Mac. Open the flash drive and navigate to the /config folder. Locate and delete (or rename to .old ) the following files: network.cfg
The onboard Ethernet is disabled at the hardware level.
To set a static IPv4 quickly, from the Unraid web GUI: