Ch899 Chouchin Radio Controlled Clock Instructions Free |link| Jun 2026

Clears the internal memory and restarts the alignment phase. Manual Setting Process

If you prefer to set the time manually or if the radio controlled signal is not received, follow these steps:

The CH899 chouchin movement is a reliable, low-maintenance radio-controlled movement that powers clocks from many different brands. Whether you're dealing with a simple wall clock or a cuckoo clock, the fundamental operations and troubleshooting steps are almost universally the same. By understanding its key functions—automatic sync, manual override (M.SET), forced reception (REC), and basic power management—you can confidently set up and maintain your clock for years of accurate, carefree timekeeping.

Use a paperclip or a pen tip to press the recessed button if your specific variant has one. Reinsert a brand-new, premium alkaline battery. ch899 chouchin radio controlled clock instructions free

Setting up a radio-controlled clock ensures perfect timekeeping, but losing the manual makes troubleshooting difficult. The CH899 Chouchin movement is a popular wave-receptor clock mechanism used in many traditional, modern, and novelty wall clocks. It automatically synchronizes with official atomic time radio signals to maintain split-second accuracy.

| | Likely Cause | Solution | | :--- | :--- | :--- | | Hands won’t move after installing batteries | Protective pin not removed | Remove the plastic pin from the mechanism on the back of the clock | | | Dead or weak battery | Install one fresh, high-quality alkaline battery | | Clock shows the wrong time | Poor radio signal reception | Press and hold the REC button for 5 seconds to force a new signal search. Place the clock near a window | | | Incorrect battery | Try a new, high-quality battery as old ones can interfere with reception | | Clock hands stuck at 4, 8, or 12 o’clock | Clock hasn't received the signal yet | Be patient. It can take up to 24 hours for the clock to find the signal. The strongest reception is typically between midnight and 4 am | | Clock is consistently a few minutes off | Clock is in the wrong "mode" | The clock may be in a manual mode. Press the RESET button to clear the memory and let it search again | | Cuckoo call doesn’t work (Weltbild model) | Cuckoo call is turned off | Press the ADJUST button once to activate the cuckoo cycle | | | Light sensor is active (nighttime) | The cuckoo is automatically silent at night. Check again during the day |

The clock will sit silently at 12:00 while it searches for the atomic radio signal. This process can take anywhere from . Do not touch any buttons during this window. Clears the internal memory and restarts the alignment phase

If the clock does not receive a signal (e.g., in a basement or remote area), set it manually:

Follow these steps to get your CH899 clock running perfectly. Step 1: Installing the Battery Open the battery compartment on the back of the clock.

Always use new, high-quality alkaline batteries. Weak batteries will prevent the clock from receiving the radio signal. if the time is wrong)

: To manually trigger a search (e.g., if the time is wrong), press and hold the REC button for 3 seconds. The hands will return to 12:00 to begin searching.

If you cannot receive a signal, use these steps to set the time yourself:

The initial setup for the standard CH899 radio-controlled clock is simple.

Press and hold the M.SET button for approximately 3 to 5 seconds. The hands will start moving. Advance the Time: Hold the M.SET button down to make the hands move rapidly.

Remove the battery cover on the back of the clock.