Atr 72600 Maintenance 80 Manual Pdf 2021

After replacing a PW127M engine on airframes 72600-72900, the torque sensor ground offset must be measured at ambient temperature above 30°C . If calibrated below 25°C, a phantom 8% torque demand will inhibit autothrust arming.

) to a speed where fuel introduction and ignition can safely sustain combustion. Component Breakdown

If a third attempt is needed, a 30-minute cooling period is mandatory to prevent starter burnout. Hot Starts and Aborts atr 72600 maintenance 80 manual pdf 2021

A 2021 revision of the ATR 72-600 AMM contains critical updates regarding:

As La Perle taxied out, I sat on my toolbox and reopened the PDF. I highlighted Section 80-23, added a sticky note in red: “Forget this step, and you’ll spend a day chasing ghosts.” After replacing a PW127M engine on airframes 72600-72900,

Do you need help or warning light? Share public link

“Negative,” I replied. “The bird is silent. The autothrust won’t arm. It’s like the brain is there, but the spinal cord is cut.” Component Breakdown If a third attempt is needed,

Loosen the V-band coupling clamp securing the starter-generator to the accessory gearbox (AGB) pad.

If the engine fails to start, wait 1 minute before the second attempt.

, several key documents affecting ATR maintenance were updated: MRBR (Maintenance Review Board Report):

Mandatory utilization of grounded wrist straps when touching or testing the engine electronic control (EEC) components connected to the starting circuit. 5. Navigating Digital Document Layouts (PDF Maintenance)